Extend the Life of your Hydraulic Elevator System!
Avoid hot oil problems like nuisance shutdowns, leveling problems, and oil odor by installing the MEI AOC Oil Cooler.

Benefits

• Smoother stops and starts
  Extended component life
  Fewer shutdowns
  Overall performance improvement
  Oil filter with sight gauge

Recommended Applications

• Twin jack holeless applications with two- or three-stage telescopic jacks.
• Heavily used single-stage twin jack holeless projects.
• Roped hydraulic applications with moderate usage and travel exceeding 25 feet.
• Any hydraulic elevator with high usage.

Specifications

• 3/4 HP, 115 VAC, 1 phase, 7.2 FLA pump motor
  or 208-230 VAC, 1 phase, 3.6 FLA pump motor
• 1/4 HP, 115VAC, 1 phase, 3.6 FLA 1900 CFM fan motor
  or 208-230 VAC, 1 phase, 1.4 FLA 1900 CFM fan motor
• Heat removal: 17,500 BTU/hr @ 40°F temp delta
• 8 GPM, 75 PSI cast iron pump
• Weighs approximately 140 lbs
• Adjustable thermostat control
• 80db at 3 ft.
• Electrical requirement, 115 VAC, 1 phase, 20amp separate circuit
• 10 micron filter in hydraulic oil line
• Filter head with sight gauge to indicate when the filter needs to be changed
• Heavy gauge frame construction
• Includes all fittings and hardware needed for adjacent-mount installation
• Includes instructions for installation

 Printable Brochure / Order Form

Product Tour

How it Works
The Oil Cooler can be mounted to the power unit or located in a remote location*. When the oil temperature in the reservoir reaches a preset limit, it is circulated through the radiator. This process reduces the oil temperature by nearly 40°F, depending on site conditions. The oil is also filtered as it runs through the system, which results in enhanced performance and extended component life. The filter head has a sight gauge to indicate when the filter needs to be changed.

*Remote location must be within 110 feet horizontally or 55 feet vertically from the power unit. Piping, wiring, and conduit to remote location are not included.